I'm a windshield replacement technician, and believe I can offer some insight to your problem.
first off the 350z and infiniti have the same glass their is NO antenna or heater wires or magical unicorn sensor.
aftermarket glass is readily available and is really no better or worse than the OEM stuff. (i have aftermarket in my car)
Things to worry about would be the skill of the shop doing the work. the glass is nothing special but what's required to replace it is a little more work than the average car takes to be replaced (the process is similar to an older ford mustang for these cars).
The outer A pillars must be removed all the way to the rear of the doors, they are secured with screws (hidden under the rubber window seal) and clips.
If the rubber window seal is not replaced correctly you will have wind whistles and your car will leak water from the side windows. (usually the upper corners)
the plastic cowling must also be removed (under the wipers.) its straight forward, just a bunch of plastic clips and a couple 10mm bolts. but some installers wont remove them in order to save time.
also after the window is removed, they WILL scratch the pinchweld area in order to cut down the old glue. this is necesary and unavoidable, however a good installer will use an approved automotive primer on the scratches in order to eliminate any rusting issues.
again, dont worry about the brand of glass, worry about the installer doing the work.
any questions PM me
-Brian
__________________
2004 6mt Coupe, 2003 Kawasaki Ninja ZX6-R.
|